Innovative Products decorative concrete supplies, stamped overlay, spray deck. 

                                            For An Innovative Industry c

 

Home

Products

Show Room

Training

Technical

Request Catalog

Renew-Crete® Systems               
2020 Murrell Rd.  
Rockledge, FL 32955 
888-287-8962 Phone
321-636-8882  Phone
888-875-7012 Fax
321-636-7343 Fax 
Hit Counter

Quick Links

Color Charts

Stamp Mix

Spray-Coat

Re-Coat

Patch-It

Color Hardener

Powder Release

Acid Stain

Stamping Tools

Liquid Release

Concrete Sealers

Plastiform®

Constr. Sprayers

Crack Repair

Co-Polymers

Stamped Concrete

Stamped Overlays

Training Schedule

Re-Coat

Making old concrete look new!

For the Ultimate in concrete repair & resurfacing, rely on Renew-Crete®.  

Re-Coat is a co-polymer modified resurfacing compound especially formulated to dry to a light gray color to resemble newly cured concrete. Re-Coat is perfect to restore old stained concrete surfaces, rain damaged slabs, scaling or dusting concrete. This product can be applied from a featheredge up to 2” thick, broomed, squeegeed, or troweled on.  Re-Coat is available in 30 standard colors as well as neutral gray.

Directions:

Surface Preparation:

        The concrete surface must be clean and free of all loose material, oil residue, sealers or paints.  Clean thoroughly by using a pressure washer with a degreaser or stripper if necessary.  Etch the surface using a 1-4 muriatic acid solution. Rinse clean and neutralize. 

Mixing instructions 50 Lb. Unit:

        In a clean 5-gallon pail measure 1.5 gallons of clean water.  Using a drill with a mixing wand, slowly add the dry Re-Coat to the water as you are running the mixing wand.  Once you have added all the material, continue to mix thoroughly for 2 minutes to a fluid consistency with no lumps.

Application Instructions:

Patch & leveling:           Start by misting the surface with water, (surface should be damp only, no standing water) then apply Patch-It. Screed where necessary, smooth with a round edged fresno or pool trowel, keeping all tools clean and moist., finish as desired (i.e. broom texture, etc.) Allow all patch and leveled areas to dry before applying Re-Coat (1-5 hours).

 

Broom Finish:            Start by misting the surface with water, then apply the Re-Coat with squeegee, allow material to dry slightly, follow with a broom.

Note:  If a great deal of patching has been done you may need to apply second coat over the entire area to ensure color uniformity. Wait until the first application is dry, (1-3 hours) then re-apply.

Coverage: 1-50 Lb. unit will cover approximately. 200-250 sq. ft. broomed or squeegeed, 25 sq. ft. at ¼” thick.

Re-Coat, another innovative product from Renew-Crete® Systems!

 
Copyright © 1999, 2000, 2001, 2002, 2003, 2004 Renew-Crete Systems, Inc.. All rights reserved.
Last revised: July 30, 2002